#1
6th August 2014, 09:36 AM
| |||
| |||
VITMEE Automotive Engineering Question Paper
Will you please provide the VITMEE Automotive Engineering Question Paper?
|
#2
6th August 2014, 01:14 PM
| |||
| |||
Re: VITMEE Automotive Engineering Question Paper
Here I am providing the list of few questions of VITMEE Automotive Engineering Question Paper which you are looking for . Which type of power plant requires maximum expenditure a Hydel power plants b Nuclear power plants c Thermal power plants d Gas based power plants A wire is placed on the top of a transmission line to protect from a surge high voltage b Direct lightning strocks c indirect lightnin strocks d Switching over voltages Ans: Direct lightning strocks Base load of a power station stands for a 2-4 hours/day b 4-8 hours/day c 8-12 hours/day d 12-24hours/day Ans: 12-24hours/day A wire is placed on the top of a transmission line acts as a acts as a phase wire b acts as neutral c acts as a transmission wire d acts as ground wire The inductance is not used in lag network because of (a) big size b) time delay and hysteresis losses (c) high reactance (d) none of these Which of the following can be magnified by magnetic amplifier (a) voltage (b) current (c) power (d) none of above Saturation in a stable control system can cause (a) conditional stability (b) over damping (c) low level oscillations (d) high level oscillations The type-0 system has (a) net pole at the origin (b) no pole at the origin (c) simple at one origin (d) two poles at the origin Excessive noise in control systems can cause a) reduction in bandwidth (b) reduction in gain (c) saturation in amplifying stages (d) oscillations In control systems, excessive bandwidth should be avoided because (a) noise is proportional to bandwidth (b) it leads to low relative stability (c) it leads to slow speed of response (d) none of these In most systems, an increase in gain leads to (a) larger damping ratio (b) smaller damping ratio (c) constant damping ratio (d) none of these The function of the safety resistor in ohm meter is to (a) limit the current in the coil (b) increase the voltage drop across the coil (c) increase the current in the coil (d) protect the battery Which of the following instruments is free from hysteresis and eddy current losses? (a) M.l. instrument (b) electrostatic instrument (c) electrodynamometer type instrument (d)all of these The dielectric loss of a capacitance can be measured by (a) Wien bridge (b) Owen bridge (c) Schering bridge (d) Maxwell bridge A step function is applied to the input of a system and output is of the form y = t, the system is (a) stable (b) unstable (c) not necessarily stable (d) conditionally stable Reed frequency meter is essentially a (a) recording system (b) deflection measuring system (c) vibration measuring system (d) oscillatory measuring system In measurements made using a Q meter, high impedance elements should preferably be connected in (a) star (b) delta (c) series (d) parallel A digital voltmeter measures (a) peak value (b) peak-to-peak value (c) rms value (d) average value Pick out the one which does not belong to majority of items i.e; the odd thing a. Leaf spring suspension b. Coil spring suspension d. Air suspension Ans : A Which of the following factors is not related to the effect of independent front suspension a. Reducing the unsprung masses b. Reducing tyre wear d. Elimination of gyroscopic couples Ans : D |
|