Sample Question Paper SSC Junior Engineer Civil

I have done B.Tech in Civil Engineering and now want to apply for SSC (Staff Selection Commission) Junior Engineer Civil Post. I am looking for previous year question papers of SSC JE Civil for preparation of exam so please provide me the same?

Sir I am looking for the Sample Question Paper SSC Junior Engineer Civil so can you please provide me the same

[Kiran Chandar]

Hi friend below I am giving you the Sample Question Paper SSC Junior Engineer Civil

1. Timber can be made reasonably fire-resistant by

a. soaking it in Ammonium Sulphate

b. coating with Tar paint

c. pumping creosote oil into timber under

d. seasoning process

2. Which one of the following statements is the correct description of the structure of

fibre board ?

a. Thin slices of superior quality of wood

b. Streamed mass of wood dusts, wood

high pressure

c. Thin and narrow wood shavings are

d. Thin and narrow wood shaving are

3. Match List I(Constituents of bricks) with

List II(corresponding influence) and select

the correct answer :

List I

A. Alumina

B. Silica

C. Magnesia

D. Limestone

List II

1. Colour of brick

2. Plasticity recovery for moulding

3. Reacts with silica during burning and

4. Preserve the for on brick at high

A B C D

a. 2 1 4 3

b. 3 4 1 2

are glued and pressed on the surface of inferior wood wool and other vegetable fibres are pressed hard to a thickness varying from 3 mm to 12 mm soaked in a refractory binder material and pressed hard soaked in a refractory binder material and pressed hard causes particles to unite together and development of strength temperature and prevents shrinkage


3. Dipping

4. Open tank application

The correct sequence of these methods in

the increasing order of their effectiveness

is :

a. 1, 3 4, 2

b. 3, 4, 2, 1

c. 2, 3, 4, 1

d. 4, 2, 1, 3

7. Match List I with List II and select the

correct answer :

List I (Name of defect)

A. Cupping

B. Bowing

C. Chucks

D. Knots

List II(Definition)

1. Caused by wood limbs encased by the

2. Caused by grain irregularities in the

3. Small cracks appearing at the ends of

4. Unequal shrinking in the radial and

A B C D

a. 1 2 3 4

b. 4 3 2 1

c. 1 3 2 4

d. 4 2 3 1

8. Match List I with list II and select the

correct answer :

List I (Type of cement)

A. Ordinary Portland cement

B. Rapid hardening cement

C. Low heat cement

D. Sulphate resistant cement

List II(Characteristics)

1. The percentage of C3S is maximum

2. The percentages of C2S and C3S are

3. Reacts with silica during burning and wood of the free trunk board and can be eliminated by proper stacking boards caused by too rapid drying tangential direction and is of the order of 50% the same and of the order of 40% causes particles to unite together and development of strength


d. Fe2O3, SiO2 , Al2O3, CaO


Sample Question Paper SSC Junior Engineer Civil