 2019 2020 Student Forum Hindustan Petroleum Corporation Limited placement sample papers
 User Name Remember Me? Password

#1
 Unregistered Guest Posts: n/a Hindustan Petroleum Corporation Limited placement sample papers

I am student of the Electronics and electrical? I am searching for the HPCL Electronics and electrical Placement-Papers? Please tell me from where I can download this?
#2
 Super Moderator Join Date: Apr 2013 Posts: 61,184 Re: Hindustan Petroleum Corporation Limited placement sample papers

The Hindustan Petroleum Corporation Limited offers the recruitments for the following branches. These are as follows:

Mechanical
Civil
Electrical
Electronics & Telecommunications
Instrumentation
Chemical

You are asking for the HPCL Electronics and electrical Placement-Papers. Here I am providing this. This is as follows:

1. The unit of magnetic flux density is

(A) gauss
(B) tesla
(C) bohr
(D) weber/sec
Ans: (B)

2. The equation of continuity defines the relation between

(A) electric field and magnetic field
(B) electric field and charge density
(C) flux density and charge density
(D) current density and charge density
Ans: (D)

3. The current in a coil changes from 5A to 1A in 0.4 second. The induced voltage is 40 V. The self inductance in henry is

(A) 1
(B) 2
(C) 4
(D) 10
Ans: (C)

4. The maximum power will be transferred from a voltage source to a load when

(A) the source impedance is half that of the load impedance
(B) the source impedance is equal to that of the load impedance
(C) the source impedance is twice that of the load impedance
(D) both source and load impedances must be zero

Ans: (B)

5. The total number of branches in a network is equal to b. The graph of the network has n number of branches. The minimum number of line currents is

(A) b+n
(B) b
(C) b-n
(D) n
Ans: (C)

6. In a travelling electromagnetic wave, E and H vector fields are

(A) perpendicular in space .
(B) parallel in space.
(C) E is in the direction of wave travel.
(D) H is in the direction of wave travel.
Ans: C

7. A wave is incident normally on a good conductor. If the frequency of a plane electromagnetic wave increases four times, the skin depth, will

(A) increase by a factor of 2.
(B) decrease by a factor of 4.
(C) remain the same.
(D) decrease by a factor of 2.
Ans: D

8. A hollow rectangular waveguide acts as a

(A) High pass filter
(B) Low pass filter
(C) Band pass filter
(D) Low frequency radiator
Ans: A

9. Divergence theorem is applicable for

(A) static field only
(B) time varying fields only
(C) both static and time varying fields
(D) electric fields only
Ans: C

10. For a rectangular wave guide, 2.5cm x 1.2cm, dominant cut off wavelength is

(A) 5 cm
(B) 2.5 cm
(C) 2.4 cm
(D) 3.7 cm
Ans: A

11. When a steady current is passed through a ballistic galvanometer, then the deflection will be

(A) maximum
(B) zero
(C) twice the normal value as it depends on Hibbert magnetic standard
(D) None of the above

Ans: (B)

12. The measurement of frequency can be carried out with

(A) Owen’s bridge
(B) Wien’s bridge
(C) Maxwell’s inductance-capacitance bridge
(D) Schering’s bridge
Ans: (B)

13. The following material is not used for making a piezoelectric transducer

(A) Rochelle salt
(B) Barium titanate
(C) Chlorium sulphide
(D) Quartz
Ans: (C)

14The velocity factor of a transmission line

(A) is governed by the relative permittivity of the dielectric.
(B) is governed by the skin effect.
(C) is governed by the temperature.
(D) All of the above.

Ans: A

15. By using feedback in control systems, the sensitivity to parameter variation is improved.This is achieved at the cost of

(A) stability
(B) loss of system gain
(C) transient response
(D) reliability
Ans: (B)

16. The phase-lead compensation is used to

(A) increase rise time and decrease overshoot.
(B) decrease both rise time and overshoot
(C) increase both rise time and overshoot
(D) decrease rise time and increase overshoot
Ans: (B)

17. In position control systems, the device used for providing rate feedback is called

(A) potentiometer
(B) synchro
(C) tachogenerator
(D) servomotor
Ans: (C)

18. Given a badly underdamped control system, the type of cascade compensator to be used to improve its damping is

(B) phase-lag
(D) notch filter

Ans: (B)

19. Analog data acquisition systems are used when

(A) wide bandwidth and low accuracy are required/sufficient
(B) narrow bandwidth and low accuracy are required/sufficient
(C) wide bandwidth and high accuracy are required
(D) narrow bandwidth and high accuracy are required

Ans: (A)

20. In a transmission line terminated by characteristic impedance, Zo

(A) There is no reflection of the incident wave.
(B) The reflection is maximum due to termination.
(C) There are a large number of maximum and minimum on the line.
(D) The incident current is zero for any applied signal.
Ans: A
#3
 Unregistered Guest Posts: n/a Re: Hindustan Petroleum Corporation Limited placement sample papers

Can some one provide me sample placement papers of Hindustan Petroleum Corporation Limited?
#4
 Super Moderator Join Date: Apr 2013 Posts: 36,100 Re: Hindustan Petroleum Corporation Limited placement sample papers

As you should get sample placement papers of Hindustan Petroleum Corporation Limited, so here I am giving following sample placement papers:

Hindustan Petroleum Corporation Limited Sample Placement Paper
(Control Systems)

1. An open loop control system has its
(a) control action independent of the output or desired quantity
(b) controlling action, depending upon human judgment
(c) internal system changes automatically taken care of
(d) both (a) and (b)
(e) all (a),(b) and (c)

2. A servo system must have
(a) feedback system
(b) power amplifier to amplify error
(c) capacity to control position or its derivative
(d) all of these
(e) none of these

3. The major disadvantage of a feedback system may be
(a) Inaccuracy
(b) inefficiency
(c) Unreliability
(d) instability
(e) Insensitivity

4. Properties of a transfer function
(a) It is ratio of two polynomials is S and assumes zero initial conditions
(b) It depends on system elements and not input and output of the system
(c) Coefficients of the powers of S in denominator and numerator are all real constant. The order of denominator is usually greater than or equal to the order of numerator
(d) All of these
(e) It is a function which transfer one physical system into another physical system.

5. The classical analogous of a simple lever is
(a) Capacitor bridge
(b) transformer
(c) mutual inductor
(d) either of these

6. Two blocks G1(s) and G2(s) can be cascaded to get resultant transfer function as
(a) G1(s) + G2(s)
(b) G1(s) / G2(s)
(c) G1(s) G2(s)
(d) 1+G1(s) G2(s)
(e) 1-G1(s)G2(s)
(f) two blocks cannot be cascaded

7. The principles of homogeneity and super position can be applied to
(a) linear time invariant system
(b) non-linear time invariant system
(c) digital control system
(d) both (a) and (b)

8. Pick up the nonlinear system
(a) automatic voltage regulator
(b) d.c. servomotor with high field excitation
(c) temperature control of a furnaces using thermistor
(d) speed control using SCR
(e) all of these

9. Signal flow graph (SFG) is a
(a) polar graph
(b) semi log graph
(c) log log graph
(d) a special type of graph for analyzing modem control system
(e) a topological representation of a set of differential equations

10. Disadvantages of magnetic amplifier
(a) time lag, less flexible, non-sinusoidal waveform
(b) low power consumption and isolation of the active circuit
(c) saturation of the core
(d) all of these

11. Pick up false statement regarding magnetic amplifiers
(a) The gate coil of an ideal magnetic amplifier has either zero or infinite inductance
(b) Resistance of control and gate winding is very small
(c) Magnetic amplifier gas dropping load characteristics
(d) Magnetic amplifiers are not used to control the speed of d.c. shunt motor
(e) Magnetic amplifiers can be used in automatic control of electric drivers of higher rating.

12. High power amplification is achieved by using
(a) push pull amplifier
(b) amplidyne
(c) magnetic amplifier
(d) DC amplifier
(e) D.C. generator

13. Pick up false statement regarding servomotors
(a) The d.c. servomotors are lighter than equivalent a.c. servomotors
(b) The d.c. servomotors develops higher starting and reversing torque than equivalent a.c. servomotor.
(c) A drag cup a.c. servomotor has one windings on stator and other on rotor
(d) Output power of servomotors varies from 1/20 W to 100 W

14. To reduce steady state error
(a) decrease natural frequency
(b) decrease damping
(c) increase damped frequency
(d) increase time constant
(e) increase gain constant of the system

15. A good factor for Mp should be
(a) less than 1
(b) lying between 1.1 and 1.5
(c) more than 2.2
(d) zero
(e) infinity

16. Pick up false statement. Routh-Hurwitz criterion
(a) is used for determining stability of a system
(b) is an algebraic procedure
(c) gives the exact location of roots of the characteristic equation
(d) does not indicate relative degree of stability or instability

17. Which of the following is the time domain method of determining stability of a control system
(a) Bode plot
(b) Nyquist plot
(c) Nicholos chart
(d) Routh-Hurwitz array
(e) Constant M and (fy) locus
(f) Root locus technique

18. The technique which gives transient response quickly as well as stability information is
(a) Nyquist plot
(b) Routh-Hurwitz criteria
(c) Bode plot
(d) Root locus plot
(e) Nichols plot

19. The bandwidth can be increased by use of
(a) phase lag network
(b) phase lead network
(c) both (a) and (b) in cascade
(d) both (a) and (b) in parallel
(e) none of these

20. Nyquist plot is drawn on
(a) semi log graph paper
(b) log log graph paper
(c) polar graph paper
(d) centimeter graph paper

21. If the gain margin is positive and the phase margin is negative the system is
(a) stable
(b) unstable
(c) indeterminist

22. The Bode plot is applicable to
(a) all phase network
(b) minimum phase network
(c) maximum phase network
(d) lag lead network
(e) none of these

23. The valid relation between setting time ts and rise time tr is
(a) tr>ts
(b) ts>tr
(c) ts=tr
(d) none of these

24. As a root moves further away from imaginary axis the stability
(a) increases
(b) decreases
(c) not affected
(d) none of these

25. Flat frequency response means that the magnitude ratio of output to input over the bandwidth is
(a) variable
(b) zero
(c) constant
(d) none of above Quick Reply

Message:
Options

 Thread Tools Search this Thread Show Printable Version Email this Page

All times are GMT +5.5. The time now is 08:11 PM.

 Contact Us - Management.ind.in Discussion Forum - Archive - Top Partners : StudyChaCha