#1
31st December 2015, 03:44 PM
| |||
| |||
WD SSC enabled
Hello sir I want to know about the enabled module of WD SSC so please provide me suitable information about the same.
|
#2
31st December 2015, 03:45 PM
| |||
| |||
Re: WD SSC enabled
WD SATA hard drives are factory set for workstation/desktop use. For enterprise storage requirements, the jumpers can be set to enable spread spectrum clocking or power-up in standby modes. WD SSC WD SATA drives are shipped from the factory either with or without a jumper shunt in the spread spectrum clocking (SSC) enable/disable position (on pins 1 and 2). It is not necessary to add or remove the jumper shunt on the drive for workstation/desktop use. For enterprise storage environments, use the following advanced settings: 1. SSC Mode (Default 1): Spread spectrum clocking feature enabled or disabled. Default 1 setting is disabled or jumper shunt placed on pins 1–2. Removing the jumper enables the spread spectrum clocking feature. SSC Mode (Default 2): Spread spectrum clocking feature enabled or disabled. Default 2 setting is disabled or no jumper shunt placed on pins 1–2. Adding the jumper to pins 1–2 enables the spread spectrum clocking feature. PM2 Enabled Mode: To enable power-up in standby (power management 2 or PM2) mode, place a jumper on pins 3–4. This mode enables controlled spinup by spinup command in accordance with ATA standard and is mainly for server/workstation environments operating in multiple-drive configurations. Note: The PM2 feature is not available on all WD SATA drives. OPT1: 150 MB/s data transfer speed enabled or disabled. Default setting is disabled. To enable 150 MB/s data transfer speed, place a jumper on pins 5–6. OPT2: reserved for factory use (pins 7–8). |
|