Questions Bank For Computer Control Subject

Will you please provide the list of questions of the Computer Control Subject?

[Kiran Chandar]

Here is the list of few questions of the Computer Control Subject which you are looking for .

This set of Computer Organisation and Architecture MCQ focuses on “Hardwired Control”.

1. ________ are the different type/s of generating control signals.
a) Micro-programmed
b) Hardwired
c) Micro-instruction
d) Both a and b

2. The type of control signal are generated based on,
a) contents of the step counter
b) Contents of IR
c) Contents of condition flags
d) All of the above

3. What does the hardwired control generator consist of ?
a) Decoder/encoder
b) Condition codes
c) Control step counter
d) All of the above

4. What does the end instruction do ?
a) It ends the generation of a signal
b) It ends the complete generation process
c) It starts a new instruction fetch cycle and resets the counter
d) It is used to shift the control to the processor

5. The Zin signal to the processor is generated using, Zin = T1+T6 ADD + T4 .BR…
a) True
b) False

6. What does the RUN signal do ?
a) It causes the termination of a signal
b) It causes a particular signal to perform its operation
c) It causes a particular signal to end
d) It increments the step counter by one

7. The name hardwired came because the sequence of operations carried out are determined by the wiring.
a) True
b) False

8. The benefit of using this approach is
a) It is cost effective
b) It is highly efficient
c) It is very reliable
d) It increases the speed of operation

9. The disadvantage/s of the hardwired approach is
a) It is less flexible
b) It cannot be used for complex instructions
c) It is costly
d) Both a and b

10. The End signal is generated using, End = T7.ADD + T5.BR + (T5.N+ T4.-N).BRN…
a) True
b) False

Hello sir I am Seema, can you please provide me the types of questions asked in Subject named as Computer Control Process??

[sumit]

As per your demand here I am telling you the types of questions asked in Computer Control Process

1. State the theoretical properties required for a digital control algorithm?

2. State deadbeat algorithm?

3. Give the advantages and disadvantages of dead beat algorithm?

4. State dahlin algorithm?

6. Give the disadvantages of dahlin algorithm?

7. Give the difference between position and velocity algorithm?

8. Write the features of a digital PID controller

9. Explain ringing?

10. How can ringing be avoided?

11. State the conditions when a controller is said to be physically unrealisable?

12. Define robustness of a digital control algorithm?

13. What is sampler and hold?