2023 2024 Student Forum

2023 2024 Student Forum (https://management.ind.in/forum/)
-   Main Forum (https://management.ind.in/forum/main-forum/)
-   -   DMRC Junior Engineer Mechanical Exam Sample Question Paper (https://management.ind.in/forum/dmrc-junior-engineer-mechanical-exam-sample-question-paper-106070.html)

Unregistered 12th December 2014 07:55 AM

DMRC Junior Engineer Mechanical Exam Sample Question Paper
 
Will you please provide the sample Question Paper of DMRC Junior Engineer Mechanical exam ?

Quick Sam 12th December 2014 09:35 AM

Re: DMRC Junior Engineer Mechanical Exam Sample Question Paper
 
Here is the list of few questions of DMRC Junior Engineer Mechanical Exam Sample Question Paper which you are looking for .

In PERT analysis a critical activity has
A) maximum Float
B) zero Float
C) maximum Cost
D) minimum Cost
Answer : (B)

Environment friendly refrigerant R134a is used in the new generation domestic refrigerators. Its chemical formula is
A) CH C1 F2
B) C2 C13 F3
C) C2 C12 F4
D) C2 H2 F
4 Answer : (D)

The S-N curve for steel becomes asymptotic nearly at
A) 103 cycles
B) 104 cycles
C) 106 cycles
D) 109 cycles
Answer : (C)

In a rolling process, sheet of 25 mm thickness is rolled to 20 mm thickness. Roll is of diameter 600 mm and it rotates at 100 rpm. The roll strip contact length will be
A) 5 mm
B) 39 mm
C) 78mm
D) 120mm
Answer : (A)

The angle between two unit-magnitude coplanar vectors P(0.866, 0.500,0) and Q(0.259, 0.966,0) will be
A) 0° B) -30°
C) 45°
D) 60°
Answer : (C)

15 A lot has 10% defective items. Ten items are chosen randomly from this lot. The probability that exactly 2 of the chosen items are defective is
A) 0.0036
B) 0.1937
C) 0.2234
D) 0.3874
Answer : (B)

the execution of a CNC part program block NO20 GO2 X45.0 Y25.0 R5.0 the type of tool motion will be
A) circular Interpolation — clockwise
B) circular Interpolation — counterclockwise
C) linear Interpolation
D) rapid feed
Answer : (A)

In an interchangeable assembly, shafts of size 25.000+0.040mm mate with holes of size 25.000+0.020 mm. The maximum possible clearance in the assembly will be
A) 10 microns
B) 20 microns
C) 30 microns
D) 60 microns
Answer : (D)

S-N curve for steel becomes asymptotic nearly at
A) 103 cycles
B) 104 cycles
C) 10 6 cycles
D) 10 9 cycles
Answer : (C)


All times are GMT +5. The time now is 05:45 PM.

Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.
SEO by vBSEO 3.6.0 PL2


1 2 3 4