2023 2024 Student Forum > Management Forum > Main Forum

 
  #2  
13th July 2015, 09:01 AM
Super Moderator
 
Join Date: Apr 2013
Re: Wrong Answers in PGCET

As you want to know about that how many marks will be deducted in PGCET for a wrong answer so I want to tell you that there is no negative marking in PGCET.
The 1 mark will be given for each correct answer.

Here I am also providing you the question paper below
Question Paper of PGCET
Q-8 A circuit has a resistance of 11 W, a coil of inductive reactance 120 W, and a
capacitor with a 120-W reactance, all connected in series with a 110-V, 60-Hz power
source. What is the potential difference across each circuit element?
A) (a) VR = 110 V, (b) VL = VC = 1.2 Kv
B) (a) VR = 120 V, (b) VL = VC = 2.4 kV
C) (a) VR = 4.8 V, (b) VL = VC = 0 kV
D) (a) VR = 5.0 V, (b) VL = VC = 8.0 V
Q-2 Applying DeMorgan's theorem to the expression , we get
A) (A+B)+C
B) A(B + C)
C) Both A & B
D) None of above
Q-4 Refer Below figure to Determine the resonant frequency…
A) 123.4 kHz
B) 61.7 kHz
C) 45.97 kHz
D) 23.1 kHz
Q-4 Express the decimal number 57 in binary.
A) 100101
B) 111010
C) 110010
D) 111001
A D V E R T I S E M E N T
Q-5 A vertical electric dipole antenna
a) radiates uniformly in all directions.
b) radiates uniformly in all horizontal directions, but more strongly in the vertical
direction.
c) radiates most strongly and uniformly in the horizontal directions
d) does not radiate in the horizontal directions


Q-6 A particle oscillates according to the equation y=5.0 cos 23 t, where y is in
centimeters. Find its frequency of oscillation and its position at t=0.15 s.
a) f = 23 Hz, y = -4.8 cm
B) f = 3.7 Hz, y = -5.0 cm
C) f = 3.7 Hz, y = -4.8 cm
D) f = 3.7 Hz, y = +4.8 cm
Q-7 A 10.0-µF capacitor is in series with a 40.0-W resistance, and the combination is
connected to a 110-V, 60.0-Hz line. Calculate (a) the capacitive reactance, (b) the
impedance of the circuit, (c) the current in the circuit, (d) the phase angle between current
and supply voltage
A) (a) 0.0038W (b) 305W (c) 0.415 A (d) voltage lags by 8.58°
B) (a) 266W (b) 269W (c) 0.409 A (d) voltage lags by 81.4°
C) (a) 16 kW (b) 72 kW (c) 2.75 A (d) voltage lags by 6.63°
D) (a) 2.6 kW (b) 262W (c) 0.256 MA (d) voltage leads by 81.4°
Q-8 A circuit has a resistance of 11 W, a coil of inductive reactance 120 W, and a
capacitor with a 120-W reactance, all connected in series with a 110-V, 60-Hz power
source. What is the potential difference across each circuit element?
A) (a) VR = 110 V, (b) VL = VC = 1.2 Kv
B) (a) VR = 120 V, (b) VL = VC = 2.4 kV
C) (a) VR = 4.8 V, (b) VL = VC = 0 kV
D) (a) VR = 5.0 V, (b) VL = VC = 8.0 V
Q-9 What is the primary function of multiplexing?
A ) To match the frequency range of a signal to a particular channel.
B ) To reduce the bandwidth of a signal.
C ) To select one radio channel from a wide range of transmitted channels. D ) To allow a number of signals to make use of a single communications channel.
Q-10 A second step to further increase system capacity is a digital access method called
TDMA (Time Division Multiple Access). Using the same frequency channelization and
reuse as FDMA analog but adding a time sharing element, the effective capacity is:
A) Doubled
B) Tripled
C) Reduced by one third
D) Unchanged
Q-11 What are Pseudo-Random noise sequences, or P/N Sequences?
A) P/N Sequences are known sequences which exhibit the properties or chracteristics of


random sequences
B) P/N Sequences can be used to logically isolate users on the same physical (frequency)
channel
C) P/N Sequences appear as random noise to everyone else, except to the transmitter and
intended receiver
D) All of the above
Q-12 An op-amp integrator has a square-wave input. The output should be
A ) a sine wave.
B) a triangle wave
C) a square wave.
D) pure DC.
Q-13 What is the relationship between the series and parallel resonant frequencies of a
quartz crystal?
A) They are equal.
B) Parallel resonant frequency is approximately 1 kHz higher than series resonant
frequency
C) Series resonant frequency is approximately 1 kHz higher than parallel resonant
frequency.
D) none of the above
Q-14 Refer Below figure to Determine the resonant frequency…
A) 123.4 kHz
B) 61.7 kHz
C) 45.97 kHz
D) 23.1 kHz
Q-15 Which FET amplifier(s) has (have) a phase inversion between input and output
signals?
A) common-gate
B) common-drain
C) common-source
D) all of the above


Quick Reply
Your Username: Click here to log in

Message:
Options

Thread Tools Search this Thread



All times are GMT +5. The time now is 10:09 PM.


Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.
SEO by vBSEO 3.6.0 PL2

1 2 3 4