UPPCL Last Year Question Paper

Can you please give here Junior Engineer (JE) recruitment previous year question paper of Uttar Pradesh Power Corporation Limited (UPPCL)?

[Kiran Chandar]

Uttar Pradesh Power Corporation Limited (UPPCL) conducts various recruitments every year for different level posts and fields.

Here is the Junior Engineer (JE) recruitment exam previous year question paper of UPPCL.

Sample paper :
1. Timber can be made reasonably fireresistant
by
a. soaking it in Ammonium Sulphate
b. coating with Tar paint
c. pumping creosote oil into timber under
high pressure
d. seasoning process

2. Which one of the following statements is
the correct description of the structure of
fibre board ?
a. Thin slices of superior quality of wood
are glued and pressed on the surface of
inferior wood
b. Streamed mass of wood dusts, wood
wool and other vegetable fibres are
pressed hard to a thickness varying
from 3 mm to 12 mm
c. Thin and narrow wood shavings are
soaked in a refractory binder material
and pressed hard
d. Thin and narrow wood shaving are
soaked in a refractory binder material
and pressed hard

3. Match List I(Constituents of bricks) with
List II(corresponding influence) and select
the correct answer :
List I
A. Alumina
B. Silica
C. Magnesia
D. Limestone
List II
1. Colour of brick
2. Plasticity recovery for moulding
3. Reacts with silica during burning and
causes particles to unite together and
development of strength

4. Preserve the for on brick at high
temperature and prevents shrinkage
A B C D
a. 2 1 4 3
b. 3 4 1 2

c. 2 4 1 3
d. 3 1 4 2

4. In some brick masonry walls, patches of
whitish crystals were found on the exposed
surfaces, also chipping and spalling of
bricks took place from the same walls.
Which among the following are the causes
of these defects ?
1. Settlement of foundation
2. Over-loading of the walls
3. Sulphate attach
4. Efflorescence
a. 1 and 2
b. 2 and 3
c. 2 and 4
d. 3 and 4

5. Match List I with list II and select the
correct answer :
List I(Property)
A. Specific heat of an aggregate
B. Thermal conductivity of an aggregate
C. Thermal expansion
D. Durability of concrete
List II(Characteristic)
1. Breaks the bond between the aggregate
and the paste
2. Is a measure of its heat capacity
3. Is affected by differences n thermal
expansion of two different materials
4. Is a measure of its ability to conduct
heat
A B C D
a. 1 3 2 4
b. 2 4 1 3
c. 1 4 2 3
d. 2 3 1 4
6. Consider the following methods of
preservation of timber :
1. Pressure application
2. Brush application

3. Dipping
4. Open tank application
The correct sequence of these methods in
the increasing order of their effectiveness
is :
a. 1, 3 4, 2
b. 3, 4, 2, 1
c. 2, 3, 4, 1
d. 4, 2, 1, 3

7. Match List I with List II and select the
correct answer :
List I (Name of defect)
A. Cupping
B. Bowing
C. Chucks
D. Knots
List II(Definition)
1. Caused by wood limbs encased by the
wood of the free trunk
2. Caused by grain irregularities in the
board and can be eliminated by proper
stacking
3. Small cracks appearing at the ends of
boards caused by too rapid drying
4. Unequal shrinking in the radial and
tangential direction
A B C D
a. 1 2 3 4
b. 4 3 2 1
c. 1 3 2 4
d. 4 2 3 1

UPPCL JE exam sample paper







Here is the attachment.