#1
26th November 2014, 09:36 AM
| |||
| |||
SAIL electrical engineering previous year papers
Here I am looking for previous year papers for SAIL electrical engineering so please provide me?
|
#2
26th November 2014, 10:33 AM
| |||
| |||
Re: SAIL electrical engineering previous year papers
Here you are looking for previous year papers for SAIL electrical engineering, as you want here I am providing you. SAIL electrical engineering previous year papers Q.1.Two 100-W, 200-V lamps are connected in series across a 200-V supply. The total power consumed by each lamp will be _____ watts. 200 100 50 25 Q.2.The material used for fuse must have low melting point and low specific resistance high melting point and low specific resistance low melting point and high specific resistance none of these Q.3.The purpose of introducing reactor in the ignition circuit of mercury are rectifier is to limit the voltage of the circuit rate of change of flux in the circuit current in the circuit rate of change of current in the circuit Q.4.Sparking occurs when a load is switched off because the circuit has high a resistance inductance capacitance none of these Q.5.The usual value of the surge impedance of a telephone line is ______ohm. 75 600 500 250 Q.6.In the case of a lossy capacitor, series equivalent resistance value will be small large very small none of these Q.7.Time constant of an R-C circuit increases if the value of resistance is decreased increased neither (a) nor (b) either (a) or (b) Q.8.Sparking between contacts can be reduced by inserting a capacitor in parallel with contacts resistance in the line capacitor in series with contacts none of these Q.9.dBm is a ratio of power unit of power unit of voltage none of these Q.10.Decibel is a unit of frequency impedance power ratio none of these Q.11.The absolute unit of resistance is of the dimension of velocity length acceleration none of these Q.12.The absolute unit of inductance is of the dimension of time length mass none of these Q.13.The applied voltage from the circuit being checked is disconnected when an ohmmeter is used because the current will decrease the resistance the ohmmeter has its own battery no current is needed for meter movements none of these Q.14.An accurate voltmeter must have an internal impedance of very high value very low value low value none of these Q.15.A moving –coil instrument can be used to measure high frequency a.c. low frequency a.c both d.c. and a.c direct current Q.16.The voltage drop across the moving coil of a 50-µ A (f.s) PMMC meter at full- scale deflection is ---- the voltage drop across that of a 1-mA (fs) PMMC meter at full-scale deflection. less than approximately equal to greater than none of these Q.17.Voltage stress is maximum in a cable at the surface of the insulator sheath conductor none of these Q.18.The coefficient of coupling between two air core coils depends on mutual inductance and self inductances of the two coils mutual inductance between two coils only self inductances of the two coils only none of these Q.19.The location of lightning arrestor is away from the transformer near the transformer near the circuit breaker none of these Q.20.A conductor of length 1 meter moves at rt. angles to a magnetic field of flux density 1 Wb/m2 with a velocity of 25 m/s. The induced e.m.f. in the conductor will be ----- volt. 75 25 50 100 Q.21.In electrical machines, laminated cores are used with a view to reducing eddy current loss hysteresis loss Q.22.A battery always delivers power always absorbs power absorbs power when the internal resistance is non-zero but delivers power when the internal resistance is zero can absorb or deliver power depending upon the circuit to which it is connected Q.23.Decibel is a unit of voltage unit of power ratio of power none of these Q.24.Deflection of pointer of a permanent-magnet moving-coil meter for fixed current is _______ flux density in the airgap between magnetic pole shoes and coil. independent of directly proportional to inversely proportional to none of these Q.25.A moving-iron meter is useful for voltage measurement at _______frequencies. high low very high none of these Q.26.A thermocouple instruments would be used to measure alternating current only? low very low high none of these Q.27.Which of the following instruments will be used to measure alternating current only? moving – iron (attraction-types) ammeter moving – iron voltmeter permanent-magnet type ammeter induction-type ammeter Q.28.A milliammeter can be used only as an ammeter as a voltmeter both as voltmeter and ammeter none of these Q.29.To measure the e.m.f. of a Weston standard cell, one would use a/an electrostatic voltmeter hot-wire voltmeter galvanometer potentiometer–Answer Q.30.Deflection sensitivity of deflecting plates of cathode ray tube ____ the distance between deflection pates. is inversely proportional to is directly proportional to does not depend on none of these Q.31.Deflection sensitivity of deflecting plates of a cathode ray tube ___the accelerating anode (A3) voltage. is inversely proportional to is directly proportional to does not depend on none of these Q.32.A moving – coil instrument can be used to measure direct current alternating current both direct current and alternating current none of these Q.33.The frequency stability of a crystal oscillator depends upon tuned circuit crystal crystal as well as the tuned circuit none of these Q.34.Hay bridge is usually used for measuring resistance capacitance inductance none of these Q.35.Schering bridge is used for measuring capacitance inductance frequency none of these Q.36.The Wien’s bridge is particularly useful for measuring frequencies of _______value. low very high high very low Q.37.Impedance relay is used to protect line within a particular zone line beyond a particular zone the whole transmission system none of these Q.38.Buchholz relay is used in ______ protection. line generator transformer none of these Q.39.Kirchhoff’s voltage law is not valid for a non-linear network. True False Q.40.If a piece of metal wire is stretched, its resistance will increase. True False Q.41.In mesh analysis of a network, all the mesh currents must necessarily be either clock-wise or anticlock-wise. True False Q.42.An uncharged capacitor is connected across a charged one.There will flow an impulsive current through the circuit. True False Q.43.If R, L and C denote resistance, inductance and capacitance respectively, the quantity RC has the same dimensions as that of R/L. True False Q.44.If R, L and C denote resistance, inductance and capacitance respectively, then the quantity CR2 has the dimensions, of L. True False Q.45.A battery will not cause any current to flow, when it is connected across a pure capacitor, in the steady state even if the capacitor value varies with time. True False Q.46.When two capacitors C1 and C2 are connected in series, the effective capacitance is C1+C2 True False Q.47.The flux linked with a coil of inductance l carrying a current i is ddt(Li). True False Q.48.When one wants to connect two batteries in parallel to draw larger current than what can be supplied by one battery, it suffices to ensure that their e.m.f.s. are equal. True False Q.49.An ideal battery can supply infinite current True False Q.50.1 GHz means 100 Hz. True False SAIL electrical engineering previous year papers Q.1.Two coils in differential connection have self-inductance of 2 mH and 4 mH and a mutual inductance of 0.15 mH. The equivalent inductance of the combination is 5.7 mH 5.85 mH 6 mH 6.15 mH. Q.2.In a 8085 microprocessor system with memory mapped I / 0, I / 0 devices have 8-bit addresses I / 0 devices are accessed using IN and OUT instructions there can be a maximum of 256 input devices and 256 output devices. arithmetic and logic operations can be directly performed with the I / 0 data. Q.3.When 2-port networks are connected in parallel, which parameters convenient to use inverse hybrid open circuit impedance short circuit admittance transmission Q.4.The number of comparators needed in a 4-bit flash type ADC is 32 8 14 15 Q.5.Line imperfection in a crystal is called Schottky defect Frenkel defect edge dislocation Miller defect. Q.6.The frequency modulated (FM) radio frequency range is nearly 250 - 300 MHz 150 - 200 MHz 90 - 105 MHz 30 - 70 MHz Q.7.A 10 MHz square wave clocks a 5-bit ripple counter. The frequency of third flip-flop’s output would be 2 1 2.5 1.25 Q.8.Which of the following regulator provides output voltage polarity reversal without a transformer Buck regulator Boost regulator Buck-boost regulator Cuk regulator Q.9.The polarization required in ground wave propagation is Horizontal (linear) vertical (linear) Circular Elliptical Q.10.If the noise figure of a receiver is 1.6, its equivalent noise temperature is 464.00 K 174.00 K 108.75 K 181.25 K Q.11.The minimum value of the life of a transistor to be used in three section R-C phase shift oscillator is 54.4 44 29 32 Q.12.Multicavity Klystron is not a microwave device is not a good low level amplifier because of noise is not suitable to pulse operation has a high repeller voltage to insure small transit time Q.13.The value of M in the end will be Do 100 I = 1, 2 DO 200 J = 1, 2 M = M + I + J 200 CONTINUE 100 CONTINUE STOP END 10 11 12 14 Q.14.In TV system, vertical pulses are separated out from horizontal pulses by the use of integrator differentiator sweep credit sync separator Q.15.Fourier’s series expansion of an odd periodic function contains sine terms only cosine terms only Both A and B None of the above 16. The following programme is run on an 8085 microprocessor, Memory address in Hex Instruction 2000 LXI SP, 1000 2003 PUSH H 2004 PUSH D 2005 CALL 2050 2008 POP 2050 2009 HIT As the completion of execution of the program, the program the program counter of the 8085 contains ………, and the stack pointer contains …….. 2050, OFFC 2251, OFFC 1025, OCCF 1025, OCCF Q.17.200 MHz may be classified as VHF SHF UHF EHF Q.18.The principles of homogeneity and super-position are applied to : linear time variant systems non-linear time variant systems linear time invariant systems non-linear time invariant systems. Q.19.Dislocations in materials are point defect line defect planer defect surface defects. Q.20.The binary representation of 5.375 is 111.1011 101.1101 101.011 111.001 Q.21.Which one out of the following instruments should be used to measure 600 kV a.c. voltages? Hot wire instrument Electrostatic voltmeter Moving coil voltmeter Moving iron voltmeter. Q.22.For a LC parallel circuit at resonance, all the statements given below are correct except the line current is maximum at resonance the branch currents at resonance are equal the admittance is minimum at resonance the angle between the branch current is 180oC at resonance. Q.23.The Taylor series expansion of the function F(x) = x/(1+x), around x=0 is x+x2+x3+x4+……. x+x2+x3+x4+……. 2x+42+8x3+16x4+……. x-x2+x3-x4+……. Q.24.The mobility of electron in copper is :Given atomic weight = 63.54, density = 8.96 gm/cc, resistivity = 1.7×10–6 W-cm, Avogadro’s number = 6.025 ×1023 30 cm2/V-5 43.28 cm2/V-5 50 cm2/V-5 data not sufficient Q.25.If a square wave voltage having 5V average value is applied to a low pass filter, then average value of output is 10 V 2.5 V 5 V 0 V Q.26.Resistivity of electrical conductors is most affected by temperature pressure Composition all of the above. Q.27.In CCIR B-system of TV, blanking pulse is placed during equalizing pulse retrace interval between each line retrace period of vertical line none of the above. Q.28.The capacity of a channel is number of digits used in coding volume of information it can take maximum rate of information transmission bandwidth required for information Q.29.Sometimes microwave signals follow the earth’s curvature. This due to Ionospheric reflection Faraday rotation Ducting Ionospheric scatter. Q.30.The function of diplexers bridge in a TV transmitter is to prevent the loading of several transmitters by video transmitter to increase the bandwidth to increase the power output to increase the efficiency of transmission. If you want any more details about give information please let me know we will provide you. |
|