2023 2024 Student Forum > Management Forum > Main Forum

 
  #2  
16th August 2014, 04:13 PM
Super Moderator
 
Join Date: Apr 2013
Re: Operator Cum Technical Trainee Exam model paper

Here I am giving you exam pattern Steel Authority Of India LTD Operator cum Technician Trainee examination below ..

Exam pattern :
The entrance test for the recruitment of SAIL Operator cum Technician will be of 135 minute duration.
The question paper will have 5 sections each having questions of objective type pattern.

Paper Type: MCQ Based
Negative Marking: N/A
Duration: 145 Minutes
No. of Questions: 125
Maximum Marks: 250 (Paper: 1: 150 and Paper-2: 100 Marks)

Section I (45 Marks) - Reasoning
Section II (35 Marks) - Quantitative Aptitude
Section III (35 Marks) - General Awareness
Section IV (35 Marks) - English
Section V (100 Marks) - Technical questions depending on the branch of study

Syllabus Details of SAIL Technician Paper Part 1 (General Studies)
Reasoning Related MCQs– 45 marks
Quantitative Aptitude Related Competitive level MCQs- 35 marks
General Awareness Related MCQs- 35 marks
English Language and Grammar related MCQs- 35 marks

Syllabus Details of SAIL Technician Paper Part II (Technical paper)
As told above this section comprises of Technical domain related questions, basically the multiple choice questions will be asked from your specialized trade domain and the posts you’ve applied for. Like if you have applied for Mechanical or Fitter or any other trade then you have face question paper related to same domain.
Technical Paper (Relevant Engineering Discipline) -100 marks
  #3  
19th February 2016, 02:38 PM
Unregistered
Guest
 
Re: Operator Cum Technical Trainee Exam model paper

Hello sir, I’m going for attempt to an Operator Cum Technical Trainee Exam. Before attempting Operator Cum Technical Trainee Exam I ant to see which types of question was provides in model paper?
  #4  
19th February 2016, 02:41 PM
Super Moderator
 
Join Date: Apr 2013
Re: Operator Cum Technical Trainee Exam model paper

SAIL Paper pattern consist of objective queries divided into two sections. Part-I consists of aptitude queries whereas Part-II are going to be having questions from relevant discipline.


Aptitude test 150 marks
Quantitative Aptitude (35 marks)
English Verbal ability (35 marks)
Reasoning (45 marks)
General awareness (35 marks)

Relevant Engineering Discipline (Technical) 100 marks

Few question for SAIL Operator Cum Technical Trainee Exam model paper:

Ques: The efficiency and work ratio of a simple gas turbine cycle are
A. low
B. very low
C. high
D. very high

Ques: The unit of angular acceleration is
A. N-m
B. m/s
C. m/s2
D.rad/s2

Ques: Which of the following is the lightest and most volatile liquid fuel?
A. Gasoline
B. Kerosene
C. Fuel oil
D. Nitrogen

Ques: The thermal efficiency of regenerative feed water cycle is ?
a) same as simple Rankine cycle thermal efficiency
b) less than simple Rankine cycle thermal efficiency
c) greater than simple Rankine cycle thermal
d) none of the above
Answer c

Ques: In regenerative feed heating cycle, feed water is heated by
(a) extracted steam from the turbine
(b) exhaust gases from boiler
(c) heaters
(d) all of the above
Answer a

Ques: In a regenerative feed heating cycle, the greatest efficiency can be obtained when steam is extracted only from the last stage of steam turbine
(a)when steam is extracted only from the last stage of steam turbine
(b) when steam is extracted only from the first stage of steam turbine
(c) when steam is extracted only one suitable point of steam turbine
(d)when steam is extracted from several places in different stages of steam turbines
Answer d

Ques: The following is not correct for regenerative feed heating cycle:
(a) It reduces the heat rate, and hence reduces Operating cost
(b) It increases the complication of the plant
(c) It reduces irreversibly, thus heating process in boiler tends to become revers
(d) It requires less steam flow rate for a given output power
Answer d

Ques: In regenerative feed heating
(a) larger capacity boiler is required for a given output
(b) smaller capacity condenser is required for a given output
(c) turbine output decreases due to extraction of steam
(d) all of the above
Answer d

Ques: The following is correct for regenerative feed heating cycle
(a) It reduces turbine blades erosion due to moisture.
(b) It requires less maintenance.
(c) it increases turbine output power for given steam flow rate
(d) It increases temperature range in the boiler, thus more thermal stresses are
- in the boiler
Answer a

Ques: The reheating of steam in a turbine
(a) increases the efficiency of the turbine
(b) increases the output power from the turbine
(c) reduces corrosion and erosion of turbine blades
(d) all of the above
Answer d

Ques: The following is not correct for reheating cycle of steam turbine
(a) It requires less floor space
(b) It increases the work done through the turbine
(c) It reduces the erosion of the turbine blades
(d) It increases the thermal efficiency of the plant
Answer a

Ques: In reheating cycle,
(a) fuel consumption is increased by 4 to %
(b) it is preferred for low capacity plants
(c) the complexity of operation and control increases
(d) all of the above
Answer C

Ques: The law which states that heat and work mutually convertible is known as
(b) first law of thermodynamics
(a) zeroth law of thermodynamics
(c) second law of thermodynamics
(d) third law of thermodynamics
answer b

Ques: According to first law of thermodynamics
(a) network can be produced during cycle without some heat supply.
(b) network cannot be produced during a cycle without some heat supply.
(c) network cannot be produced during a cycle with some heat supply.
(d) none of the above.
answer b

Ques: A perpetual motion machine of first kind (defined as a machine which produces power without consuming any energy) is impossible according to
(b) first law of thermodynamics
(a) zeroth law of thermodynamics
(c) second law of thermodynamics
(d) none of above
answer b

Ques: If all the variables of a stream are independent of time it is said to be in
(a) steady flow
(b) unsteady flow
(c) constant flow
(d) uniform flow
answer a

Ques: The first law of thermodynamics for steady flow
(a) energy entering-energy leaving a control volume +change in stored energy.
(b) heat energy + work done +change in internal energy
(c) heat energy-work done energy balance for a specified mass of fluid
Answer: a

Ques: A definite area or space where some thermodynamic process takes place is known
(a) thermodynamic cycle
(c) thermodynamic
(b) thermodynamic system process
(d) law of thermodynamic
Answer: b

Ques: In an open thermodynamic system,
(a) neither the heat and work nor the mass cross the boundary of the system
(b) heat and work cross the boundary of system but not mass.
(c) mass cross the boundary of system but not heat and work.
(d) both the heat and work as well as mass of working substances cross the boundary of the system.
Answer: d

Ques: A thermodynamic system is refereed to be an isolated system when there s transfer of across the system boundary
(a) only mass
(b) only heat and work
(c) both mass and energy
(d) neither mass nor energy
Answer: d

Ques: when two bodies are in equal temperature with third body they are also equal temperature with each other This statement known as
(a) zeroth law of thermodynamics
(b) first law of thermodynamics
(c) second law of thermodynamics
(d) third law of thermodynamics
Answer: a

Ques: A system having single phase is called:
(a) isolated system
(b) closed system
(c) homogeneous system
(d) heterogeneous system
Answer: c

Ques: Zeroth law of thermodynamics deals with
(a) conservation of energy
(b) conservation of mass
(c) entropy
(d) thermal equilibrium
Answer: d


SAIL Operator Cum Technical Trainee Exam model paper








Quick Reply
Your Username: Click here to log in

Message:
Options




All times are GMT +5. The time now is 09:40 AM.


Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.
SEO by vBSEO 3.6.0 PL2

1 2 3 4