2023 2024 Student Forum > Management Forum > Main Forum

 
  #1  
3rd September 2014, 07:57 AM
Unregistered
Guest
 
National Thermal Power Corporation Limited Assistant Chemist Trainee last year papers

Will you please share with me the National Thermal Power Corporation Limited Assistant Chemist Trainee last year papers?
Similar Threads
Thread
Preparation tips for National Thermal Power Corporation Limited exam
National Thermal Power Corporation Limited Recruitment
National Thermal Power Corporation Limited scholarships for ST students for higher ed
National Thermal Power Corporation Limited New Delhi
National Thermal Power Corporation Ltd Trainee Chemist Exam pattern and syllabus
National Thermal Power Corporation Limited placement papers of past years
National Thermal Power Corporation Limited Assistant Chemist Trainee Exam previous ye
National Thermal Power Corporation Limited Engineer Trainee previous year question pa
National Thermal Power Corporation Limited Executive Trainee previous year GATE cut o
National Thermal Power Corporation Assistant Chemist Trainee Exam Syllabus
National Thermal Power Corporation Limited Engineer Trainee last year papers
Summer training in National Thermal Power Corporation Limited
National Thermal Power Corporation Limited Electronics and Communication syllabus
National Thermal Power Corporation Limited Supervisor Trainee last year papers
National Thermal Power Corporation Limited syllabus of Electronics of Diploma Trainee
National Thermal Power Corporation Limited Trainee Chemist Exam syllabus
Last year cut off of GATE of National Thermal Power Corporation Limited
National Thermal Power Corporation (NTPC) previous year question papers
National Thermal Power Corporation Limited GET Electrical Engineering last year quest
Reference books for National Thermal Power Corporation Limited of Graduate Trainee Ex
  #2  
3rd September 2014, 08:27 AM
Super Moderator
 
Join Date: Apr 2013
Re: National Thermal Power Corporation Limited Assistant Chemist Trainee last year pa

As you want to get the National Thermal Power Corporation Limited Assistant Chemist Trainee last year papers so here it is for you:

1. Given four unit-circle plots identify the one corresponding to a bandpass filter.
2. A 4 kHz signal is sampled at thrice the Nyquist rate and sent through a channel with error ?1%. Calc the bandwidth of the channel.
3. Given a two port network in the form of a T find o/p admittance in terms of y-parameters.
4. Connect two 1? resistors in series, then connect two 1H inductors across one of the resistors such that the ckt looks like a 1? resistor in series with a ?-section of a resistor and two inductors. With the series resistance on the i/p side, calc the transfer function of this ckt
5. Inverse laplace transform of 1/s2[d/ds(e-3s/s)]
6. Lower useful input limit of a transducer is determined by?
7. Air-cored inductors are used for low frequency/high frequency/equal frequency operations.
8. Given 4 pole-zero plots identify which one corresponds to the driving point impedance of a series resonant ckt.
9. Expression for ?(n): u(n)-u(n-1)/ u(n-1)-u(n+1)/ u(n)+u(n+1)/?
10. The sequence (2,3,4,3) is circularly even/circularly odd/circularly zero/both circularly even and odd.
11. Z-transform of 3n u(n).
12. Match the following with their characteristics: LED/LCD/nixie tube/optical fibre.
13. Numerical on a photodiode: to calculate the responsivity/sensitivity when a specified no of incident photons cause a specified no of electron generation.
14. Given an op-amp ckt obtain an expression for o/p voltage.
15. No. of encirclements made about the origin of the nyquist plot of the open loop TF:1/[(s-1)(s+2)(s+3)].
16. For a radioactive sample which decays to 12.5% of its initial value in x days, the half life is given by____
17. For a repeater in a PCM cable identify the correct sequence of actions amongst threshold/equalization/etc.
18. O/P of a delta modulator when a ramp input is fed to it.
19. Steady state error with ramp i/p for a type-0 system.
20. Creeping occurs in energy meters bcoz?
21. Ultrasonic method of flow measurement cannot be used in liquids with air bubbles/has less attenuation in air compared to liquid-identify the false statement (if any) among these.
22. Major cause of losses in a fibre optic cable: dispersion/total internal refraction/presence of core and cladding/?
23. Which layer in the OSI model is concerned with printer buffering,etc: network/session/transport/?
24. Given some function F(j?) calc its inverse CTFT.
25. Relation between laplace and z-transform: s=z/ s=ln z/ s=( ln z/T) /?
26. Maxm and minm probability error among ASK,PSK,FSK,DPSK etc
27. Which of the following is a non linear modulation scheme: PAM/QAM/PCM/?
28. Match the following functions: e-t , e-t + et, sin(?t) with causal and stable system, causal and unstable system, etc.
29. Given a ckt with a 50 ? resistor in series between two voltage sources of 10 V and 5 V magnitude calc power delivered by 5 V source.
30. Laplace transform of e-3tu(t)+e2tu(-t).
31. Which photodetector has output affected by own intrinsic noise: PN/APD/PIN/all.
32. AC signal conditioning is used for inductive and capacitive/resistive/piezoelectric transducers/all of the above.
33. When I mode is added to proportional control system stability increases/ decreases/ steady state performance deteriorates/damping increases.
34. Reset control is another name for integral/derivative/proportional/? Control.
35. Time response of system having transfer function 625/(s2+25) will be of the form?
36. Given some transfer function calc the peak response time.
37. The nyquist sampling rate of the function [sin(at)/t]2 will be?
38. The feedback topology that results in increased i/p and o/p impedance is current series/voltage series/current shunt voltage shunt.
39. Numerical on cardiac output calculation given heart rate and volume per beat.
40. In an ECG instrumentation amplifier the differential gain is provided by 1st stage/2nd stage/mismatched resistors/output stage.
41. Repeat ques 40 above for the classic 3-op amp instrum amplifier.
42. EMG signals are of the order of mV/V/?V/?
43. Computer assisted tomography is used for?
44. Numerical on electrostatic instrument, to calculate deflection given spring constant, torque etc.
45. To prevent loading of a ckt i/p impedance of a CRO should bee high/low/inductive/capacitive.
46. Addition of a zero to a 2nd order underdamped system results in increase/decrease of rise time and increase/decrease of peak overshoot.
47. For PI ctrl we obtain improved bandwidth/improved steady state performance/ worsened steady state performance/?
48. SNR of normal AM system is comparable/3 dB lower/3 dB higher/6 dB lower over DSB-SC and SSB system.
49. Which is an effective measure of the noise related performance of an amplifier: SNR/noise ratio/thermal noise/shot noise.
50. Given baseband signal freq and carrier freq calc which of the freq given will not be present for conventional AM.
51. Distinction between FM and PM at high frequencies.
52. Which of these has the least propagation delay RTL/ECL/I2L/CMOS.
53 Switching speed of CMOS is affected/unaffected by changes in supply voltage.
54. Which of these provides a measure of heart rate P/QRS complex/T/none of these.
55. Given a ckt of a logarithmic amplifier you had to identify what ckt was it.
56. JFET can operate in depletion/enhancement/both/none of the above modes.
57. When a BJT operates in saturation the junctions are fwd biased/reverse biased/?
58. BIBO stability criterion implies that poles are within/outside/on the unit circle.
59. For faithful amplification of low amplitude signals the cut-off/active/saturation regions of a transistor is used.
60. Lissajous pattern of a signal rotates 36 times per minute. if the oscillator frequency is 560 kHz then the unknown freq is?
61. % resolution of a 10 bit ADC.
62. To obtain 10 mV resolution on 5 V range how many bit DAC is to be used..
63. Why is LCD preferred to LED.
64. How will 0.6973 be displayed on 10 V range of a 4 ½ digit multimeter.
65. Which of the following cannot be used for an automatic feedback temp ctrl system thermocouple/thermometer/thermistor/IC sensor.
66. Y(n)=X(-n+3) is an example of a linear/non linear and shift variant/invariant system.
67. The falling body method is used to determine viscosity/humidity/?
68. Which of these methods of viscosity measurement gives greatest accuracy falling body method/rotating cylinder method/both/?
69. Some question on gas chromatography
70. A device having a rotor with 3 Y-connected coils and a stator is likely to be a synchro/RVDT/control transformer/?
71. In a twisted ring counter the initial count is 1000. after the 4th clock pulse its state will be?
72. A 240 kHz signal is given into a 3 bit binary ripple counter. The lowest o/p freq obtainable is?
73. For parity bit checking which of the following gates can be used XOR/NAND/OR/XNOR.
74. Why is a BJT called so..
75. Identify the expression for gauge factor of a strain gauge among the given options.
76. In a semiconductor strain gauge as tensile strain is applied what changes take place in the n and p areas..
77. How does a radioactive level gauging system work?
78. A capacitive transducer measuring level works on the principle of change in distance between plates/change in dielectric strength/?
79. For maximum power transfer in an AC circuit the condition to be satisfied is ZL+ZS=0/XL+XS=0/none of these/?where l and s refers to load and source respectively.
80. Find the transfer function from a block diagram.
81. Synchronous ctrs are preferred to asynchronous ctrs bcoz they are faster/glitches at the output can be avoided/both/none of these.
82. The lissajous figure formed on an oscilloscope looks like the English figure of 8. if the vertical channel input is 1 kHz the horizontal input freq is?
83. IE=IC for a transistor in saturation/cutoff/active/both saturation and active regions.
84. Reproducibility of measurements is called accuracy/precision/linearity/none of these.
85. Which of these is not strictly a static characteristic accuracy/precision/tolerance/linearity.
86. The shunt coil in a Q meter has resistance of the order of m?/?/k?/..
87. For measuring inductance of high Q coils the bridge used is Maxwell-wien/Schering/?
88. Which of these measures inductance in terms of capacitance Maxwell and hay/Maxwell and Schering/hay and Schering/?
89. In a flip-flop with preset and clear inputs both are applied simultaneously/clear is cleared when preset is applied/preset is cleared when clear is applied/?
90. What happens when the RET instruction is encountered by 8085
91. A 1024*8 memory chip needs how many address lines?
92. What happens when the PUSH instruction is encountered by 8051.
93. In FM relation between no of sidebands w.r.t. modulating freq
94. Numerical on DPSK.
95. A multiplexer accepts input data and provides one output all the time/one output at a time/many outputs at a time/many outputs all the time.
96. Pulse modulation is essentially a process of multiplexing/?
97. Wave shape is altered by clipper/clamper/voltage doubler/amplifier.
98. 4 signals of frequencies 100,100,200 and 400 Hz are sampled at nyquist rate and sent through TDM on a channel.the bandwidth of the channel is?
99. Superposition can be applied to a ckt with initial conditions/non-linear ckt/?
100. Kelvin’s double bridge is used for the measurement of?

Contact Details:
National Thermal Power Corporation Limited
Scope Complex,
Institutional Area,
Lodhi Rd,
Pragati Vihar,
New Delhi,
Delhi 110003 ‎
011 2436 5552 ‎
India

Map Location:

[MAP]https://www.google.co.in/maps?q=National+Thermal+Power+Corporation+Limited, +Pragati+Vihar,+New+Delhi,+Delhi&hl=en&ll=28.58727 3,77.237213&spn=0.010269,0.018475&sll=21.125498,81 .914063&sspn=22.217819,37.836914&oq=National+Therm al+Power+Corporation+&hq=National+Thermal+Power+Co rporation+Limited,&hnear=Pragati+Vihar,+New+Delhi, +South+Delhi,+Delhi&t=m&z=16&iwloc=A[/MAP]
  #3  
24th March 2015, 05:22 PM
Unregistered
Guest
 
Re: National Thermal Power Corporation Limited Assistant Chemist Trainee last year pa

I want to get National Thermal Power Corporation Limited Assistant Chemist Trainee last year paper so will you please provide me that ?
  #4  
24th March 2015, 05:23 PM
Super Moderator
 
Join Date: May 2012
Re: National Thermal Power Corporation Limited Assistant Chemist Trainee last year pa

As you want to get National Thermal Power Corporation Limited Assistant Chemist Trainee last year paper so here I am giving you some topics from which questions will come in exam paper:

A. Physical Chemistry

Atomic Structure
States of Matter
Chemical Thermodynamics
Chemical and ionic Equilibrium
Redox Reactions
Phase equilibria & Solutions
Electrochemistry
Chemical Kinetics
Surface Chemistry
Nuclear Chemistry

B. Organic Chemistry

Basic Concepts in Organic Chemistry and Stereochemistry
Qualitative and quantitative analysis and purification of organic compounds.
Preparation, Properties and reactions of Alkanes, Alkenes, Alkynes
Organic compounds with functional group containing halogens
Organic compounds with functional group containing oxygen
Organic compounds with functional group containing nitrogen
Reactions of a, b unsaturated carbonyl and acids
Polymers
Reactions of Benzene and hetro cyclic compounds
Urea and malonic easter
Spectroscopy measurements including IR, UV, NMR (proton and carbon 13)
Biomolecules – Carbohydrates, Protein, Vitamins, Nucleic Acid, Lipids, Hormones
Environmental Chemistry
Chemistry in everyday life

C. Inorganic Chemistry

Mole Concept and stoichiometry
Periodic Table
Chemical Bonding
Main Group Elements (S & P)
Transition Elements and lanthanoids
Coordination compound
Metallurgy including Ellingham diagram (basic)
Analytical Chemistry
B-inorganic Chemistry


Quick Reply
Your Username: Click here to log in

Message:
Options

Thread Tools Search this Thread



All times are GMT +5. The time now is 06:24 PM.


Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.
SEO by vBSEO 3.6.0 PL2

1 2 3 4