2023 2024 Student Forum > Management Forum > Entrance Exams

 
  #2  
19th December 2015, 04:06 PM
Super Moderator
 
Join Date: Apr 2013
Re: BARC Entrance Exam Question Paper

Here as per your demand I am providing you question paper of Electronics of BARC

1. In a twisted ring counter the initial count is 1000. after the 4th clock pulse its state will be….

2. A 240 kHz signal is given into a 3 bit binary ripple counter. The lowest o/p freq obtainable is….

3. For parity bit checking which of the following gates can be used XOR/NAND/OR/XNOR.

4. Why is a BJT called so..

5. Identify the expression for gauge factor of a strain gauge among the given options.

6. In a semiconductor strain gauge as tensile strain is applied what changes take place in the n and p areas..

7. How does a radioactive level gauging system work…

8. A capacitive transducer measuring level works on the principle of change in distance between plates/change in dielectric strength/…

9. For maximum power transfer in an AC circuit the condition to be satisfied is ZL+ZS=0/XL+XS=0/none of these/….where l and s refers to load and source respectively.

10. Find the transfer function from a block diagram.

11. Synchronous circuits are preferred to asynchronous circuits bcoz they are faster/glitches at the output can be avoided/both/none of these.

12. The lissajous figure formed on an oscilloscope looks like the English figure of 8. if the vertical channel input is 1 kHz the horizontal input freq is….

13. IE=IC for a transistor in saturation/cutoff/active/both saturation and active regions.

14. Reproducibility of measurements is called accuracy/precision/linearity/none of these.

15. Which of these is not strictly a static characteristic accuracy/precision/tolerance/linearity.

16. The shunt coil in a Q meter has resistance of the order of mO/O/kO/..

17. For measuring inductance of high Q coils the bridge used is Maxwell-wien/Schering/…

18. Which of these measures inductance in terms of capacitance Maxwell and hay/Maxwell and Schering/hay and Schering/…

19. In a flip-flop with preset and clear inputs both are applied simultaneously/clear is cleared when preset is applied/preset is cleared when clear is applied/….

20.. Which of these values of ? gives damped oscillations: 0/1/1.6/0.6

21. For a transformer of ratio 1:a and excited by a source V with impedances Z1 and Z2 on the primary and secondary side value of a for maxm power transfer should be..

22. Fourier transform of cos(w0t) is…

23. At t=0 the step response of a 1st order system is….

24. 555 can be used as a monostable/astable/freq dividing ckt/all of these.

25. In a PT when the secondary is open ckted with the primary excited what will happen.

26. If a system is marginally stable then the nature of oscillations will be…

27. Linear encoders mostly use straight binary/BCD/gray code.

28. For an accelerometer working in displacement mode the ratio of forcing freq to natural freq should be…..

29. According to Eulers theory crippling or buckling load is ____ (Wcr = Cp2EI/l2)

30. During sensible heating, specific humidity_? (remains constant)


Quick Reply
Your Username: Click here to log in

Message:
Options

Thread Tools Search this Thread



All times are GMT +5. The time now is 08:43 PM.


Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.
SEO by vBSEO 3.6.0 PL2

1 2 3 4