2023 2024 Student Forum > Management Forum > Main Forum

 
  #2  
25th July 2014, 08:12 AM
Super Moderator
 
Join Date: Apr 2013
Re: AAI Manager Electronics paper

As per your request here I am sharing the AAI Manager Electronics paper:

1. In a communication system, noise is most likely to affect the signal
(a) at the destination
(b) In the channel
(c) in the information source
(d) at the transmitter
2. Indicate the false statement. Fourier analysis shows that the saw tooth
wave consist of
(a) fundamental and subharmonic sine waves
(b) a fundamental sine wave and an infinite number of harmonics
(c) fundamental and harmonic sine waves whose amplitude decreases with
the harmonic number
(d) sinusoidal voltages, some of which are small enough to ignore in
practice
3. One of the following types of noise becomes a great importance at high
frequencies. Is the
(a) random noise
(b) shot noise
(c) impulse noise
(d) transit-time noise
4.Indicate the false statement. The square of the thermal noise voltage
generated by a resistor is proportional to
(a) its temperature
(b) Its resistance
(c) Boltzmann’s Constant
(d) the bandwidth over which it is measured
5.If the plate supply voltage for a plate modulated class C amplifier is V, the
maximum plate-cathode voltage could be almost as high as
(a)4v
(b)3v
(c)2v
(d)1v
6. Which one will be stable if characteristics equation is
(a) AS^2+BS+C
(b) AS^2-BS-C
(c) AS^4+BS^2+CS+D
(d) -AS^2+BS-C
7.When microwave follows curvature of the earth, this I know as
(a) fading
(b) Ducting
(c) troposphere scatter
(d) ionosphere reflection
8. Broadband long distance communications are originally made possible by
the advent of
(a) telegraph cables
(b) repeater amplifiers
(c) HF radio
(d) Geostationary satellites
9. Switching systems
(a) Improve the efficiency of data transfer
(b) are not used in data system
(c) require additional lines
(d) are limited to small data networks
10. Basic group B
(a) occupies the frequency range from 60 to 108 k hz
(b) consist of erect channels only
(c) is formed at the group translating equipment
(d) consist of five super group
11. In differential amplifiers, the common emitter current is made constant
(a) To make Ad (differential gain) very small
(b) To make Ac (common mode gain) very small
(c) To make the amplifier symmetrical
(d) To keep CMRR constant
12. Given BCD number 1001 0011, its decimal equivalent is
(a) 147
(b) 143
(c) 93
(d) 39
13. An amplifier has voltage gain of 50. this gain in db will be
(a) 17 db
(b) 31 db
(c) 34 db
(d) 68 db
14. In a E plane Tee, the output of the two rams are
(a) 180 degree out of phase
(b) In the same phase
(c) 90 degree out of phase
(d) none of these
15. waveguide are generally made of
(a) Aluminium
(b) Bronze
(c) Both (a) and (b)
(d) none of these

Answers
1.(b) 2.(a) 3.(d) 4.(a) 5.(a) 6.(a) 7.(b) 8.(b) 9.(a) 10.(a) 11.(b) 12.(c) 13.(c) 14.(a) 15.(c)
  #3  
21st May 2015, 12:49 PM
Unregistered
Guest
 
Re: AAI Manager Electronics paper

Here I am looking for the AAI Manager Electronics previous year question paper so can you please provide me this?
  #4  
21st May 2015, 12:49 PM
Super Moderator
 
Join Date: Apr 2013
Re: AAI Manager Electronics paper

As per your requirement here I am sharing the previous year question paper of AAI Manager Electronics exam

TECHNICAL:

1) The radiation pattern of yagiuda antenna? a)omnidirectional b)broadside c)end side

2)Function of synchro? a)transducer b) modulator c)demodulator d)encoder & decoder

3)Voltage feedback gives?

4)bcd value of 001100100001?

5)questions on micro controller pins?

6)simple questions on logic gates?

7)simple problems on rlc networks?

8)function of RAM?

9)hall effect is used to measure?

10)in RC phaseshift oscillator a condition to get oscillations is hfe>= 4K+23+29/K...

11)directivity of half wave dipole is....1.64..

12)READY signal is used in MP becoz of slow devices connected.....

13)TRAP is non maskable interrupt.....

14)value of threshold voltage?

15)function of magnetron?

16) combinational ckt means a)with memory b)with out memory c)constucted with logic gates d) both b & c

17) 2 q's on nmos transistor.

18) 1 q on wheatstone bridge, 1 q on kcl, kvl

19)what is rom ? a) temporary storage b)permanent storage c).....d)...

20) 1 q on rat race junction.

21) 1 q on txn line short ckted condition.

22)1 q on sqrt(81max).

23) take a 4 digit binary noi.e A.and then what is A+Abar= a)1101 b)1011 c)1111 d)0000

24) 1 q on op amp prob , 1 q on slew rate

25) 1 q on which filter is used for extracting sine signalof 1mhz

26) if there are 8 rc filter sections what is the individual phase shift? a)180 b)45 c)22.5


Quick Reply
Your Username: Click here to log in

Message:
Options

Thread Tools Search this Thread



All times are GMT +5. The time now is 11:30 AM.


Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.
SEO by vBSEO 3.6.0 PL2

1 2 3 4